Remove the panel by pulling down and out to release the panel mounting tabs from the drawer.
Tighten door handle sub zero.
The handle on a wolf range or wall oven should not be loose.
Loosen the screw place the handle back on flush against the door surface and tighten the screw finger tight.
Remove the magnetic caps covering the side mounting brackets.
Remove the magnetic caps covering the side mounting brackets.
See also sub zero 700 series panel removal.
A small amount of blue loctite may also prevent the mounting stud from loosening in the.
Remove the handle by removing the set screws from the underside of both handle standoffs.
There should be a small set screw on the inside of the handle opposite side of the picture.
Remove the molding trim from the hinge side of unit or bottom of drawer.
The door must be partially disassembled to tighten the handle.
Refer to the images above.
Tighten the handle.
Handle only is loose tighten the set screw on the bottom of the handle standoff with a 3 32 allen wrench.
If the end caps are tight to the door and the handle is loose service is needed.
Use whatever screwdriver or wrench is appropriate to tighten this screw and firm up the doorknob s grip on the spindle.
There is no direct metric equivalent for a 3 32 allen wrench.
Remove the screws from the side mounting brackets.
This video is about removing and re installing asub zero handle.
Tighten the handle.
Don t over tighten as they strip easily because they are so small.
Remove the screws from the side mounting brackets.
It is between.
Remove the panel by pulling down and out to release the panel mounting tabs from the drawer.
A 3 32 allan wrench is needed to tighten the set screw on a sub zero stainless steel handle.
Once the handle and standoffs are removed from the door tighten the standoff mounting stud with a flat head screwdriver.
This may be part of an allan wrench set or can be purchased through a local hardware store.
Designer formerly integrated series remove the molding trim from the door or drawer.
Tighten the handle screws from the back side.
Remove the molding trim from the hinge side of unit or bottom of drawer.
Contact factory certified service to schedule an appointment for repair.